JL Audio Car Speaker SB B 3SER CPE SDN 13TW5 User Manual

SB-B-3SER/CPE/SDN INSTR_SKU# 011256

InstallatIon

d I F F I C u lt Y :

If you choose to perform the installation yourself, it is absolutely vital that

the Stealthbox^®be properly mounted to the vehicle according to these

instructions. Failure to mount the enclosure properly presents two problems:

out

I n s t a l l a t I o n G u I d e

for the

1) The sub-bass performance will suffer due to the movement of the enclosure

caused by the force exerted by the woofer(s).

SB-B-3SER/CPE/SDN(E90\92)

2) A loose enclosure presents a serious safety hazard in the event of a collision

or sudden deceleration.

estImated tIme:

30 mIn

sKu#94281

2006-up sedan

2007-up Coupe

s t e P

Remove anything stored in the trunk so that you are working

in a clean environment.

unpack the stealthbox® and test for proper operation

before continuing!

The wiring for the Stealthbox® should go from the seam

between the seatback and the floor to the amplifier location.

Along the bottom of the rear deck from the trunk, there are

two recessed areas (as indicated by arrows at left) with two

bolts going up into the deck in each recess.

Thank you for choosing a JL Audio Stealthbox^®for your automotive sound system. With proper

installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

s t e P

The outer-most bolt in each recess must be removed.

We strongly recommend that you have your new Stealthbox^®installed by your authorized JL Audio

dealer. The installation professionals employed by your dealer have the necessary tools and experience

to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage

extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you

prefer to perform your own installation, please read this installation guide completely

before beginning the process.

s t e P

Using each of the black oxide 3/8"-16 x 1 1/2" bolts assemble

a split lock washer, flat washer, bracket, 1" spacer, through the

hole in the bracket (the slot will mount the Stealthbox® to

the bracket).

Continued on Next Page